Kohler COMMAND CV17-745 Service Manual page 187

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Figure 11-59. Installing Blower Housing.
3. Position the outer baffles and secure using the
four hex. flange screws (two long, two short) in
the front mounting holes (into cylinder head),
including any lifting strap or attached bracket(s).
Install the two short screws in the upper mounting
holes of the outer baffles (into the backing plates).
See Figures 11-60 and 11-61. Use the short screw
on the left side to mount the wire harness bracket.
Be sure any leads are routed out through the
proper offsets or notches, so they will not be
pinched between the blower housing and baffles.
See Figures 11-57 through 11-59.
Figure 11-60. Tightening Outer Baffle Front
Screws.
Figure 11-61. Tightening Short Screws for Outer
Baffles.
4. Tighten all of the shrouding fasteners. Torque the
5. If the engine had a flywheel screen that overlaps
6. Torque the four breather cover screws to 7.3 N·m
Figure 11-62. Breather Cover Fastener Torque
Sequence.
www.mymowerparts.com
blower housing screws to 6.2 N·m (55 in. lb.) in a
new hole, or to 4.0 N·m (35 in. lb.) in a used hole.
Torque the shorter M5 side baffle screws to
4.0 N·m (35 in. lb.). See Figure 11-61. Torque the
M5 side baffle screws (into cylinder head) to
6.2 N·m (55 in. lb.) in a new hole, or to 4.0 N·m
(35 in. lb.) in a used hole. Torque the two lower
M6 baffle mounting screws to 10.7 N·m
(95 in. lb.) in a new hole, or to 7.3 N·m (65 in. lb.)
in a used hole.
the blower housing, reinstall it now. For a metal
screen, apply Loctite No. 242 to screw threads
®
and torque screws to 9.9 N·m (88 in. lb.).
(65 in. lb.) in the sequence shown in Figure 11-62.
1
4
Section 11
Reassembly
11
3
2
11.17