Kohler COMMAND CV17-745 Service Manual page 150

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Section 9
Disassembly
Figure 9-34. Removing Intake Manifold.
Remove Spark Plugs
1. Remove the spark plug from each cylinder head.
See Figure 9-35.
Figure 9-35. Removing Spark Plugs.
9.10
Remove Cylinder Heads and Hydraulic
Lifters
NOTE: Cylinder heads are retained using either hex.
1. Remove the four hex. flange screws or hex. nuts
Aluminum
and washers securing each cylinder head. See
Intake
Figure 9-36. Discard the screws or nuts and
Manifold
washers once removed. Do not reuse. Studs (if
present) should only be removed if damaged or if
cylinder reconditioning is necessary. Once
removed, they must be replaced.
2. Mark the location of the push rods as either intake
or exhaust and cylinder 1 or 2. Push rods should
always be reinstalled in the same positions.
Plastic Intake
Manifold
Hex. Flange Nut
and Washer
Figure 9-36. Removing Cylinder Head Fasteners.
3. Carefully remove the push rods, cylinder heads,
and head gaskets. See Figure 9-36.
www.mymowerparts.com
flange screws or hex. flange nuts and
washers on studs. Do not interchange or mix
components, as the cylinder heads may have
different machining, unique to each fastening
method.
Hex. Flange
Screws