Update; Calibrating The Buttonhole Foot No. 3A - Bernina 560 Instruction Manual

Setup Program

update

2

calibrating the buttonhole foot no. 3a

50
⦁
⦁
It is recommended to save the data and the settings of the sewing computer
before the update is carried out.
⦁
⦁
⦁
It is then checked if:
1
3
►
After the successful update a message appears and sewing-/embroidery
computer is ready for use.
►
If the data and the settings aren't on the sewing computer anymore after the
update:
⦁
►
⦁
⦁
⦁
⦁
►
►
The buttonhole foot No. 3A is adjusted to this sewing computer and should
only be used on this sewing computer.
034790.50.04 _2013-03_Manual_B560_EN
Do not remove the BernIna uSB stick until there is a message
which indicates the end of the update.
insert BERNINA USB stick with the new software version
touch «Update»-icon
touch icon 1
the data of the sewing computer is saved on the USB stick
touch «Update»-icon 2 to start the procedure
►
a BERNINA USB stick is inserted
►
there is enough free space available
►
the correct software version is on the stick
the data and settings are accepted
if the update cannot be started or if there are problems during the update
process, an error message appears
touch icon 3
the data on the stick are saved on the sewing computer
touch «Calibration»-icon
attach buttonhole foot No. 3A
lower buttonhole foot No. 3A
touch «Start/Stop»-button
the buttonhole foot No. 3A moves forward and backwards
the buttonhole foot No. 3A is calibrated and the sewing computer indicates
whether the calibration was successful