Thread Needle; Changing The Presser Foot - Bernina 560 Instruction Manual

Sewing preparation

thread needle

1
2
1

changing the presser foot

24
Position the needle by pressing the foot control once (1 stitch).
⦁ raise the needle
⦁
lower the presser foot
⦁ turn power switch to «0» (off)
⦁ hold thread to the left and back
⦁ press lever 1 down and hold it
⦁ guide thread around the hook 2 to the right in front of the needle
c 3
⦁ put the thread from the front into the guide 3 until it catches in the wire hook
⦁ release lever 1
►
needle is threaded
⦁
pull the thread to the back and
4
⦁
put the thread under the foot and pull it from front to back over the thread
cutter on left side of the head frame 4, cut
Threads release automatically as soon as the first stitch is sewn.
removing the presser foot
⦁ raise the needle and presser foot
⦁
turn power switch to «0» (off)
⦁ raise the clamping lever
⦁ remove the presser foot
attaching the presser foot
⦁
guide the presser foot upwards over the cone
⦁ press the clamping lever down
034790.50.04 _2013-03_Manual_B560_EN