Stitch plate
markings on the stitch plate
1
̶ the stitch plate is marked with vertical, horizontal and diagonal lines in mm
and inches
̶ the lines help to guide the fabric for sewing seams and precise topstitching,
etc.
̶ the horizontal markings are helpful for sewing corners and buttonholes, etc.
̶ the diagonal markings are useful for quilting
̶ needle insertion point is position «0» (center needle position)
̶ the vertical measurements correspond to the distance between the needle
and the line
2
̶ measurements are marked to the right and to the left of center needle
position
removing the stitch plate
⦁
press «Feed dog»-button (see page 13)
►
the feed dog is lowered
⦁
turn power switch to «0» (off)
⦁
remove presser foot and needle
⦁
press the stitch plate down at the right back corner 1 until it flips up
⦁
remove the stitch plate
replacing the stitch plate
⦁
place the stitch plate over the opening 2
⦁
press down until it clicks into place
⦁
press «Feed dog»-button
►
the feed dog is raised as soon as the first stitch is sewn
034790.50.04 _2013-03_Manual_B560_EN
Sewing preparation
25