Honeywell UDC2500 Product Manual page 55

Function Prompt
Lower Display
English Numeri
c Code
EUHRDN 206
SPPROG 207
(optional
feature)
SP Ramp
must be
disabled for
SP Program
prompts to
appear. If
SP Rate is
enabled, it
does not
operate
while an SP
Program is
running.
STRSEG 208
ENDSEG 209
RPUNIT 210
RECYCL 211
SOKDEV 212
PG END 213
4/07
Selection or Range of Setting
Upper Display
English Numeric
0 to 9999 in
Engineering units
per hour
DIS
ENAB
1 to 11
2 to 12 (always end in
a soak segment)
SOK 2
SOK 4
SOK 6
SOK 8
SOK 10
SOK 12
TIME
EU-M
EU-H
0 to 100 recycles
0 to 100
LAST (Hold at last
SP) FSAF (Manual
mode/failsafe)
UDC2500 Universal Digital Controller Product Manual
Code
RATE DOWN—Rate down value. When
making a setpoint change, this is the rate at
which the controller will change from the
original setpoint down to the new one. The
ramping (current) setpoint can be viewed as
SPn in the lower display.
Entering a 0 will imply an immediate change
in Setpoint (i.e., no rate applies).
0
SETPOINT RAMP/SOAK PROGRAM—
1 Available only with controllers that contain
this option.
SP RAMP must be disabled.
DISABLE—Disables setpoint programming.
ENABLE—Enables setpoint programming.
ATTENTION Detailed information for the
prompts for SP Programming may be found
in Section 4.21 – Setpoint Programming. The
listing below is only for reference purposes.
Start Segment Number
End Segment Number
2
4
6
8
10
12
Engineering Units for Ramp Segments
TIME in hours:minutes
0
RATE in Enineering units per minute
1
RATE in Enineering units per hour
2
Number of Program Recycles
Guaranteed Soak Deviation Value
Program Termination State
0
1
Configuration
Parameter
Definition
41