Honeywell UDC2500 Product Manual page 52

Configuration
Function Prompt
Lower Display
English Numeric
Code
AUTOMA 112
RN HLD 114
SP SEL 115
38
Selection or Range of Setting
Upper Display
English Numeric
CAL
CONF
VIEW
ALL
DIS
ENAB
DIS
ENAB
DIS
ENAB
UDC2500 Universal Digital Controller Product Manual
Code
read/write.
CALIBRATION—All groups are available for
1
read/write except for the Calibration and
Keyboard Lockout groups.
+ CONFIGURATION—Tuning, SP Ramp,
2
and Accutune groups are read/write. All
other groups are read only. Calibration and
Keyboard Lockout groups are not available.
+ VIEW—Tuning and Setpoint Ramp
3
parameters are read/write. No other
parameters are viewable.
ALL—Tuning and Setpoint Ramp
4
parameters are available for read only. No
other parameters are viewable.
MANUAL/AUTO KEY LOCKOUT—Allows
you to disable the Manual/Auto key.
0
DISABLE
1
ENABLE
ATTENTION Can only be viewed if
LOCKOUT is configured for NONE.
RUN/HOLD KEY LOCKOUT—Allows you to
disable the Run/Hold key, for either SP
Ramp or SP Program. The Run/Hold key is
never disabled when used to acknowledge a
latched alarm 1 or a Diagnostic Message.
DISABLE
0
ENABLE
1
ATTENTION Can only be viewed if
LOCKOUT is configured for NONE.
SETPOINT SELECT KEY LOCKOUT—
Allows you to disable the Setpoint Select
key.
0
1
DISABLE
ENABLE
ATTENTION Can only be viewed if
LOCKOUT is configured for NONE.
Parameter
Definition
4/07