Configuration Procedure; Table 3-3 Configuration Procedure - Honeywell UDC2500 Product Manual

Configuration

3.3 Configuration Procedure

Introduction
Each of the Set Up groups and their functions are pre-configured at the factory.
The factory settings are shown in Table 3-4 through Table 3-15 that follow this
procedure.
If you want to change any of these selections or values, follow the procedure in Table
3-3. This procedure tells you the keys to press to get to any Set Up group and any
associated Function parameter prompt.
Procedure
ATTENTION
The prompting scrolls at a rate of 2/3 seconds when the SET UP or FUNCTION key is held in.
Also, or
Step Operation
Enter Set Up
1
Mode
2 Select any Set
Up Group
3 Select a Function
Parameter
4 Change the
Value or
Selection
Enter the Value
5
or Selection
6 Exit Configuration
34
keys will move group prompts forward or backward at a rate twice as fast.

Table 3-3 Configuration Procedure

Press
Upper Display = SET
Setup Setup
Lower Display = TUNING (This is the first Set Up Group
title)
Sequentially displays the other Set Up group titles shown in
Setup Setup
the prompt hierarchy in Table 3-2 Configuration Prompt
Hierarchy.
You can also use the
groups in both directions. Stop at the Set Up group title that
describes the group of parameters you want to configure.
Then proceed to the next step.
Upper Display = the current value or selection for the first
Function Function Function
Lower Display = the first Function prompt within that Set Up
Sequentially displays the other function prompts of the Set
Up group you have selected. Stop at the function prompt
that you want to change, then proceed to the next step.
Increments or decrements the value or selection that
appears for the selected function prompt. If you change the
value or selection of a parameter while in Set Up mode then
or
decide not to enter it, press M-A RESET once—the original
value or selection is recalled.
Enters value or selection made into memory after another
Function Function Function
key is pressed.
Exits configuration mode and returns controller to the same
Lower Lower Lower
state it was in immediately preceding entry into the Set Up
Display Display Display
mode. It stores any changes you have made.
If you do not press any keys for 30 seconds, the controller
times out and reverts to the mode and display used prior to
entry into Set Up mode.
UDC2500 Universal Digital Controller Product Manual
Result
or keys to scan the Set Up
function prompt of the selected Set Up
group.
group.
4/07