First steps
Setting up the base and charger (if included)
The base and charger are designed for use in dry rooms in a temperature range
of +5°C to +45°C.
¤
Set up the base at a central point in the building on a level, non-slip surface
or mount the base (Gigaset S790 only) or charger on the wall (
Please note
Pay attention to the range of the base.
This is up to 300 m in unobstructed outdoor areas and up to 50 m inside
buildings. The range is reduced when Eco Mode (
The phone's feet do not usually leave any marks on surfaces. However, due to
the multitude of different varnishes and polishes used on today's furnishings,
the occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u
Never expose the telephone to the influence of heat sources, direct sunlight
or other electrical devices.
u
Protect your Gigaset from moisture, dust, corrosive liquids and fumes.
Connecting the base
¤
First connect the
power adapter 1.
¤
Then connect the
telephone jack
and insert the
cables into the
cable ducts.
Please note:
u
The power adapter must always be connected, as the phone will not oper-
ate without a mains connection.
u
Use only the power adapter and phone cord supplied. Pin connections on
telephone cables can vary (pin connections
10
2
1
2
¢
¢
page 53) is activated.
1
1
¢
page 76).
page 82).