Table of Contents
Advertisement
s
Select screensaver and press
.
§OK§
Press the display key.
§Save§
If the screensaver conceals the display,
briefly press a to show the idle display.
Setting large font
You can increase the font size of print and
symbols in call lists and in the directory to
improve readability. Only one entry is
shown at a time on the display instead of
several entries and names are abbreviated
if necessary.
Ï
¢
¢
v
Display
Press display key (³= on).
§Change§
Setting the colour scheme
You can set the display to be shown in var-
ious colour combinations.
Ï
¢
¢
v
Display
Select
Colour Scheme
.
§OK§
•
Setting the display Backlight
Depending on whether or not the handset
is in the base/charger, you can activate or
deactivate the backlight. If it is activated,
the display is permanently dimmed. If the
backlight is deactivated it is switched on
by pressing any key. In this case the
pressed key has no other function.
Ï
¢
¢
v
Display
The current setting is displayed.
¤
You can enter data in the following
fields:
In Charger
Select
or Off.
On
Out of Charger
Select
On
or Off.
Please note
With the
setting, the standby
On
time of the handset can be signifi-
cantly reduced.
¢
Large Font
¢
Colour Schemes
(1 to 5) and press
¢
Backlight
Press the display key.
§Save§
•
Activating/deactivating auto
answer
If you activate this function, when you
receive a call you can simply lift the hand-
set out of the base/charger without having
to press the talk key c.
Ï
¢
¢
v
Telephony
Press display key (³= on).
§Change§
Changing the speaker/earpiece
volume
You can set the loudspeaker volume for
speaker mode and the earpiece volume to
five different levels.
During a conversation via the earpiece or
in speaker mode:
ø/ ÷
Press the side key to call up the
Handset Volume menu.
Change the volume by press-
ing ø (louder) or ÷ (qui-
eter).
or
t
Press the control key to call up
the Handset Volume menu.
Set the earpiece or speaker
volume by pressing r.
The setting will automatically be saved
after approximately 3 seconds, if not then
press the display key
If t is assigned to another function,
¢
e.g., call swap (
page 31):
Open menu.
§Options§
Select and press
Volume
Configure setting (see above).
Please note
u
The settings for the earpiece also
apply to a connected headset.
u
You can also set the call volume
using the menu (
Handset settings
¢
Auto Answer
.
§Save§
.
§OK§
¢
page 27).
63
Advertisement
Table of Contents
