Ptz Address Setting; Activating The Ptz Status On Close Option - Honeywell FUSION User Manual

FUSION DVR Digital Recording and Transmission System
7.7

PTZ ADDRESS SETTING

Some protocols support software address settings. The following section explains
these settings.
RX Address 1
RX Address 2
Previous ID
New ID
Set ID
PT Driver
Address
7.7.1

ACTIVATING THE PTZ STATUS ON CLOSE OPTION

1. Start by creating a Preset or Tour for the selected camera.
2. Select either Start Tour or Go To Preset.
3. Press OK or APPLY to save.
7–12
This option was added for a particular line of receivers that support 2
ID addresses. This is the first RX address.
This option was added for a particular line of receivers that support 2
ID addresses. This is the second RX address.
This option was added for a particular line of receivers that support 2
ID addresses. This option displays the current RX address ID.
This option was added for a particular line of receivers that support 2
ID addresses. This option is for entering a new RX address ID.
This option was added for a particular line of receivers that support 2
ID addresses. This option is for setting the new RX address.
This option is for specifying the PTZ ID address that the PTZ is set
to. This option must be set correctly in order for the DVR to
communicate with the PTZ. This option can be beneficial when large
amounts of PTZ are chained together.