Setting Dial Tone Detection; Telephone Line Interference/Voip - Ricoh 1195L Basic User's Manual

Setting Dial Tone detection

When you send a fax automatically, by
default your machine will wait for a fixed
amount of time before it starts to dial the
number. By changing the Dial Tone setting to
Detection you can make your machine dial as
soon as it detects a dial tone. This setting can
save a small amount of time when sending a
fax to many different numbers. If you change
the setting and start having problems with
dialling you should change back to the default
No Detection setting.
a
Press , 0, 5.
b
Press a or b to choose Detection or
No Detection.
Press OK.
c
Press .
80
Telephone line
B
interference/VoIP
If you are having difficulty sending or
receiving a fax due to possible interference
on the telephone line, we recommend that
you adjust the equalization for compatibility to
reduce the modem speed for fax operations.
a
Press , 2, 0, 1.
b
Press a or b to choose Basic(for
VoIP), Normal or High.
 Basic(for VoIP) cuts the modem
speed to 9600 bps. When you
change the Compatibility to
Basic(for VoIP), the ECM
feature is only available for fax
sending.
For a standard telephone line: If you
regularly experience interference on
your standard telephone line try this
setting.
If you are using VoIP: VoIP service
providers offer fax support using
various standards. If you regularly
experience fax transmission errors
try this setting.
Normal sets the modem speed at

14400 bps.
 High sets the modem speed at
33600 bps.
Press OK.
c
Press .
Note
VoIP (Voice over IP) is a type of phone
system that uses an Internet connection,
rather than a traditional phone line.
B