Troubleshooting - Washer - Maytag Neptune SL-3 Use And Care Manual

Super stack
Hide thumbs Also See for Neptune SL-3:
Table of Contents

Advertisement

Available languages

Available languages

T T
ROUBLESHOOTING
Check these points if your clothes washer...
Won't Fill
Won't
Tumble
Won't Spin
or Drain
Door Locked
Shut; Will
Not Open
- W
ASHER
• Be sure the door is tightly closed.
• ON light should be lit.
• Plug cord into a live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control dial to the proper cycle and push the START/STOP button.
Be sure the buttons are fully depressed.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Open and close the door, then push the START/STOP button.
• Check for low water pressure.
• Check fuse or reset circuit breaker.
• Turn the control dial to proper cycle and push the START/STOP button.
Be sure the buttons are fully depressed.
• Close the door and push the START/STOP button. For your safety, the
clothes washer will not tumble or spin unless the door is closed.
• ON light should be lit.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call
for service.
• Close the door and push the START/STOP button. For your safety, washer
will not tumble or spin unless the door is closed.
• After pressing the START/STOP button, it may take a few moments before the
clothes washer begins to spin.The door must lock before spin can be achieved.
• Press the START/STOP button to stop the washer.
• It may take 1
to 2 minutes for the door lock mechanism to disengage.
1
2
• Pull on the door indentation opposite the hinges.
20
(Continued on next page.)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents