Replacing Washer Tub Light; Reversing The Washer Door - Maytag Neptune SL-3 Use And Care Manual

W
R R
EPLACING
Instructions for replacing the bulb:
1. Unplug or disconnect the stacked unit from the
electrical power supply.
2. Open the door and use a Phillips screwdriver to
remove the screw attaching the light cover to the
door lock assembly.
3. Pull down on the light cover.
4. Unscrew the light bulb counter clockwise from the
socket.
R
EVERSING THE
Clothes washer door swing direction can be changed using the following procedure:
1. Swing door fully open and support it while removing four counter sunk hinge screws. These screws hold hinges
to the door assembly.
2. Remove door and lay carefully aside. Transfer the four color-matched door screws to the opposite side of the
door assembly.
3. Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to cabinet (opposite
side).
4. Remove hinge and bracket from cabinet by moving them up and down to a position where they are released.
5. Install hinge and bracket in swapped locations and drive screws to attach them securely to the cabinet.
6. Compare top hinge and top bracket to bottom hinge and bottom bracket for correct assembly position.
7. Repeat procedures 4 through 6 for assembling the bottom hinge to cabinet and bottom bracket to cabinet.
8. Support door in fully open position on hinge side and drive four counter sunk hinge screws to securely attach
hinges to the door assembly.
9. Close door and check to see the clothes washer operates properly.
T L
ASHER UB IGHT
W D
ASHER OOR
5. Replace the bulb with a 120 volt, 10 watt candelabra
base light bulb and rotate clockwise.
6. Replace the light cover by inserting the front tabs into
the door lock assembly and push the rear of the light
cover into position.
7. Replace the screw into the light cover/door lock
assembly.
8. Plug in or reconnect stacked unit to the power
supply.
11