Level Washer - Maytag MVWX5SPAW0 Installation Instructions Manual

(4 (4
12. Secure drain hose 14. Adjust leveling feet
Laundry Tub Standpipe Wail | |
ro.)
if washer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
Secure drain hose to laundry tub leg, drain standpipe, or inlet
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck leveiness of washer and repeat
hoses for wail standpipe with cable tie.
as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
LEVEL WASHER
IMPORTANT: Level washer properly to reduce excess noise
and vibration.
( e,
13. Check levelness of washer rc
15. Tighten leveling feet
Place level here
will support weight of washer.
Place level here
Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check leveiness a
of sides. Check levelness of front using lid, as shown. Rock When washer is level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts counterclockwise on
leveling feet tightly against washer cabinet.
HELPFUL TIP: You may want to prop washer with
washer back and forth to make sure ail four feet make solid
contact with floor. If washer is level, skip to step 15.
wooden block.
Not Level
LEVEL
Not Level