Leveler Assembly - Life Fitness 97Te Service Manual

Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Leveler Assembly
Special Service Tools Required: NONE
WARNING! MAKE CERTAIN THAT TREADMILL IS
PROPERLY SUPPORTED BEFORE REPLACING AND
INSTALLING NEW LEVELER ASSEMBLY.
1. Turn the unit power OFF at the ON/OFF Switch, and
then unplug the line cord at the wall outlet.
1. Lift treadmill up just enough to allow removal of leveler
assembly, and then support with suitable blocks.
2. Remove the four leveler mounting bolts and hardware.
3. Install new leveler assembly in reverse order of
removal.
NOTE: Mounting holes in the leveler bracket are of a non-
symmetrical pattern, and therefore can only fit the holes in
the bottom of the frame one way.
4. Level the unit by turning the leveler foot until the leveler
firmly contacts the floor.
5. When unit is level, tighten the stop nut. Make certain
the stop nut is properly seated against the pivot pin.
NOTE: It's important that unit is leveled before
using. An unleveled machine can cause the striding belt to drift to one side.
Leveler
Assembly
Flat Washer (4)
Lock Washer (4)
Hex Bolt (4)
3-43
Mounting
Bolt
Bracket Leveler
Pivot Pin
Stop Nut
Leveling Foot