Default Operator; Figure 7.11. Second Page Of The 'Keyboard Operators' Tab - Honeywell MAXPRO-Net Commissioning Manual

7.6 KEYBOARD OPERATORS, CONTINUED

Figure 7.11. Second Page Of The 'Keyboard Operators' Tab

7.6.1

Default Operator

Operator(1) is usually defined as the default operator. This default operator would be
used when NO operator environment is required in the system. It is defined to restrict
access to nothing, except for the CONFIGURATION MENU option of the SYSTEM MENU
screen. The operator names will NOT be displayed so the keyboard description would
be used to indicate monitor selection. All video input source groups could be used,
alarm display groups can be managed, any keyboard can be signed ON as this
operator, and this operator can be signed-ON to as many keyboards as necessary (at
the same time). The tilt (up and down) joystick directions have been swapped. This is
generally preferred.
Rev. B
CAUTION: It is easier to get a system up and running
with the default operator. Introducing special operators
with their specific privileges should be done at a later
stage of commissioning.
7-18 HMXMC001013
31-Mar-06