6.12 Defining Auxiliary Control Output; Figure 6.10: Auxiliary Control Output Tab - Honeywell MAXPRO-Net Commissioning Manual

6.12 DEFINING AUXILIARY CONTROL OUTPUT

Selection of the Auxiliary Control Outputs tab allows for direct editing of all the
properties for each control output. The details of each of the properties are described
below.
Control Output
Number
Description
Subrack ID
Rev. B

Figure 6.10: Auxiliary Control Output Tab

Auxiliary Control Outputs
The Control Output Number is purely a reference number used to
distinguish one control output from another. The control output number field
is NOT a changeable field.
This is an 18-character description used to identify the control output. It is
not used by MAXPRO-Net at all and it is purely for operator reference.
Enter up to an 18-character description and press Enter on the keyboard.
Specifies the subrack ID number where the control output module resides.
The valid range is 1 – 99. If a high level or mimic panel output is being used,
the number is prefixed with an "H". If a keyboard output is being used the
number is prefixed with a "K".
Enter the subrack ID number and press Enter on the keyboard.
For VideoBlox Subrack, this represents the 'V'+communication port
number to which the VideoBlox alarm concentrator AVBPIT is connected.
Valid range: 'V'+maximum communication ports.
6-40 HMXMC001013
31-Mar-06