Table of Contents
Advertisement
Alarm Set
Alarm Set
This submenu allows you to configure the ALARM alert type and duration.This alarm type is used
in conjunction with PIR cameras offered by LOREX, but not included with this system. Alternative-
ly, you may use an External motion sensor that connects to the monitors' ALARM BLOCK. Refer
to Appendix #6 (Connecting a Motion / Alarm Device) on Page 45.
1. ALARM - Configures the ALARM type for an alarm
event. Navigate by pressing the
to highlight, and press the OK button to switch
between ALARM modes:
• OFF - No display
• OSD (On Screen Display) - Visual alert only [AL]
• OSD + BUZZER - Both Visual and Audible alerts
2. CH1 - CH8 - Set the alarm mode for cameras 1
through 8.
• Change the Alarm Interval - Navigate by
pressing the
number of seconds, and press the OK button
to select. Use the
the number of seconds for alarm display, and
press the OK button to accept the change.
• Press the
and
type OK button to change between alarm
modes. Alarm Modes include OFF (no alarm),
N/O (Normally Open) and N/C (Normally
Closed). Press OK to accept the change.
NOTE: This N/O N/C Setting is for the external
alarm input terminal ONLY.
3. RETURN - Return to the MAIN MENU. Navigate
by pressing the
and
press the OK button to select
4. EXIT - Return to the camera view. Navigate by
pressing the
and
press the OK button to select
26
and
and
buttons to highlight the
and
buttons to change
buttons to highlight the alarm
buttons to highlight, and
buttons to highlight, and
buttons
ALARM
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
RETURN
EXIT
[ALARM SET]
:
[OFF]
:
10 SEC
[N/O]
:
10 SEC
[N/O]
:
10 SEC
[N/O]
:
10 SEC
[N/O]
:
10 SEC
[N/O]
:
10 SEC
[N/O]
:
10 SEC
[N/O]
:
10 SEC
[N/O]
:
[
]
:
[
]
Advertisement
Table of Contents
