Multitech MultiModem MT5600ZDXV Owner's Manual page 32

Command: D s
Values:
Default:
Description:
Command: DS n
Values:
Default:
Description:
Dial
s = dial string (phone number and dial modifiers)
none
Dial telephone number s , where s may up to 40
characters. Dial string modifiers:
0 - 9 DTMF digits 0 to 9
* The "star" digit (tone dialing only)
# The "gate" digit (tone dialing only)
A-D A, B, C, and D DTMF digits. Country specific; some
countries may prohibit these digits.
L Redial last number. (Must be placed immediately
after ATD.)
P Pulse-dial following numbers in command.
T Tone-dial following numbers in command
V Switch to speakerphone mode and dial the follow-
ing number. Use ATH command to hang up.
W Wait for a new dial tone before continuing to dial.
(X0, X1, X3, or X4 must be selected.)
S Dial a telephone number previously stored using the
&Zn=x command (see &Zn=x command for further
information). The range of n is 0-3.
, Pause during dialing for time set in register S8.
; Return to command mode after dialing. (Place at
end of dial string.)
! Hook flash. Causes the modem to go on-hook for
one-half second, then off-hook again (time speci-
fied in S29).
@ Wait for quiet answer. Causes modem to wait for a
ringback, then 5 seconds of silence, before process-
ing next part of command. If silence is not detected,
the modem returns a NO ANSWER code.
$ Wait for credit card dialing tone before continuing
with the dial string (wait contingent on S7 setting).
^ Toggles data calling tone enable/disable: applicable
to current dial attempt.
Dial Stored Telephone Number
n = 0–3
none
Dial a number previously stored in directory number n
by the &Zn=x command .