Mt5600Zdxv Soundcard Connections - Multitech MultiModem MT5600ZDXV Owner's Manual

Figure 2-3. MT5600ZDXV SoundCard Connections
To connect to a 3rd party sound card, perform the following steps:
1. Obtain a stereo male-to-male patch cord (can be purchased at a local
PC retail store).
2. Place one end of a stereo male-to-male patch cord into the "SPKR or
LINE OUT" jack of the ZDXV and the other end into the "LINE IN " jack of
the sound card. This lets you to hear the activity of the modem whether
it is originating or answering a call or playing a recorded message using
the bundled Trio software.
3. Place the two stereo microphones (do not use mono microphones) far
enough apart from each other to eliminate feedback (e.g., one on each
side of the monitor). Feedback will only occur if the microphones are too
close to each other. Make sure speakers are amplified with power source
being either a battery or AC outlet.
4. Place the microphone and speakers far enough apart from each other
to eliminate feedback. Plug the connector of both microphones into the
"MIC IN" jack of both the SoundCard and the ZDXV.
O N
O F F
IC
R M
S P K
"SPKR" or "LINE
"MIC IN" Jack to
OUT" to connect connect to an
to an optional
optional
Speaker--connect Microphone.
to the "LINE IN"
of a 3rd Party
Sound Card.
Power Switch
ON/OFF