Storage; Maintenance - Stamina 5125u Owner's Manual

COMPUTER INSTRUCTIONS
OPERATION DESCRIPTIONS
1. To stop a running program, stop pedaling for 4 seconds to switch into "STOP" mode. In this mode, you
can move the pedals again to continue to run the current program or, you can press the SET button to
select a new program. The functional values of DISTANCE and CALORIES will continue to accumulate.
2. When you complete a program, you can stop pedaling and press SET button to select a new program.
The functional values of DISTANCE and CALORIES will continue to accumulate. This will allow you to
run several programs and still know the total DISTANCE and CALORIES during the workout.
3. If you want to restart with a new program, press and hold the MODE button down for two seconds to
reset all of the function values to zero. Press SET button to select a new program.
4. The computer will shut off automatically after 3 minutes of inactivity and all function values will be reset
to zero.
HOW TO INSTALL AND REPLACE BATTERY:
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AA batteries, two batteries included.
Refer to the illustration to install or replace the batteries.
NOTE:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.

STORAGE

1. To store the 5125u Magnetic Bike simply keep it in a clean dry place.
2. The 5125u Magnetic Bike is approximately 33 1/4" long x 19 1/8" wide x 54" tall. These dimensions may
vary. Please measure your 5125u Magnetic Bike if exact dimensions are needed.
3. Lift the 5125u Magnetic Bike from the REAR STABILIZER(3) and HANDLEBAR(5) to move.
4. To avoid damage to the electronics, remove the batteries before storing the 5125u Magnetic Bike for
one year or more.

MAINTENANCE

The safety and integrity designed into the 5125u Magnetic Bike can only be maintained when the 5125u
Magnetic Bike is regularly examined for damage and wear. Special attention should be given to the following:
1. Adjust the TENSION KNOB(25) and verify that the Magnetic System provides tension. The Magnetic
System should provide many years of use.
2. Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise.
3. Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
4. Do not step on any portion of the plastic cover when getting on or off the Bike. This can cause the plastic
cover to crack.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the 5125u Magnetic Bike removed
from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the 5125u Magnetic Bike.
8. Keep your 5125u Magnetic Bike clean by wiping with an absorbent cloth after use.
15
AA Batteries