Life Fitness LC9500R Service Manual page 92

Lifecycle Recumbent Bikes LC95R, LC91R, LC85R, R9, R7, 95Ri, 93Ri, 90R, and 95Re
How To... Replace the Idler Roller
Special Service Tools: NONE
Note: An access hole in the crank pulley
exist to allow a socket to access the idler
bracket mounting bolt to loosen.
1. Remove the right side shroud. See
"How To..." in this section.
2. Rotate the crank pulley until the idler
bracket mounting bolt is visible
through the access hole in the crank
pulley, then loosen this bolt.
3. Loosen the belt tension by loosening
the adjusting bolt on the idler
bracket.
4. Remove the idler nut and pull off the
idler roller. Discard idler roller.
5. Install new idler roller in reverse
order.
6. Adjust belt tension 100-110 lbs by
moving the idler bracket down. Insert
a straight blade screwdriver in the
slotted lip of the bracket to obtain
specified tension. When belt tension
is achieved, then tighten the
mounting bolt and adjustable bracket
bolt.
Mounting
Bolt
Crank Pulley
Access Hole
16
Crank Pulley
Adjusting
Idler
Bolt
Roller