Dell C2665dnf User Manual page 211

Auto Receive Tel/Fax Available Range: 0–255 seconds
Auto Receive Available Range: 0–255 seconds
Ans/Fax
Junk Fax Setup On
Off
Sent Fax Forward Off
Forward
Print and Forward
Print and E-mail
Fax Forwarding Number
2 Sided Printing On
Off
Remote Receive On
Off
Remote Receive Available Range: 00–99
Tone
Discard Size Off
On
Auto Reduction
Redial Attempts Available Range: 0–13
Interval of Redial Available Range: 1–15 minutes
Resend Delay Available Range: 3–255 seconds
Tone / Pulse Tone
Pulse (10PPS)
Pulse (20PPS)
Prefix Dial On
Off
Prefix Dial Number
Fax Cover Page On
Off
*1
Fax Header On
Off
Sets the interval at which the printer goes into the fax receive mode
after the external telephone receives an incoming call in 0 to 255
seconds.
Sets the interval at which the printer goes into the fax mode after the
external answering machine receives an incoming call in 0 to 255
seconds.
Rejects faxes sent from unwanted numbers by accepting faxes only
from the fax numbers registered in the Phone Book.
Does not reject faxes sent from unwanted numbers.
Does not forward any of the incoming faxes to a specified destination.
Forwards the incoming faxes to a specified destination.
Prints the incoming fax and forwards it to a specified destination.
Prints incoming faxes and also forward them to a specified e-mail
address.
Sets the destination to which incoming faxes will be forwarded.
Prints the received fax on both sides of a sheet of paper.
Does not print the received fax on both sides of a sheet of paper.
Receives a fax by pressing a remote receive code on the external
telephone after picking up the handset of the telephone.
Does not receive a fax by pressing a remote receive code on the
external telephone after picking up the handset of the telephone.
Sets the tone to start Remote Receive.
Prints any excess at the bottom of a fax page without discarding it.
Discards any excess at the bottom of the page.
Automatically reduces a fax page to fit it onto the appropriate sized
paper.
Sets the number of redial attempts to make when the destination fax
number is busy, within the range of 0 to 13.
Sets the interval between redial attempts within the range of 1 to 15
minutes.
Sets the interval between transmission attempts within the range of 3
to 255 seconds.
Sets the dialing type to Tone.
Sets the dialing type to Pulse (10PPS).
Sets the dialing type to Pulse (20PPS).
Sets a prefix dial number.
Does not set a prefix dial number.
Sets a prefix dial number of up to five digits. This number dials
before any auto dial number is started.
Attaches a cover page to faxes.
Does not attach a cover page to faxes.
Prints the information of the sender on the header of faxes.
Does not print the information of the sender on the header of faxes.
Understanding the Tool Box Menus
209