Life Fitness 8500 Service Manual page 94

Step 4
Detach and unwrap the WIRE HARNESS (E) (10P,
3P, (4P 9500HR Only)) located at the top of the
MONOCOLUMN (F). Holding the CONSOLE
SUPPORT ASSEMBLY (#7) with the handgrips
facing upward, feed the WIRE HARNESS up
through the neck and out the top access hole.
Carefully lower the CONSOLE SUPPORT
ASSEMBLY into the MONOCOLUMN.
CAUTION: BE CAREFUL NOT TO PINCH THE
WIRE HARNESS (E) WHEN ASSEMBLING THE
CONSOLE SUPPORT ASSEMBLY (#7) TO THE
MONOCOLUMN (F).
Step 5
Using two HEX SOCKET HEAD CAP SCREWS
(#1) and two FLAT WASHERS (#8), secure the
CONSOLE SUPPORT ASSEMBLY (#7) to the
MONOCOLUMN (F). Tighten the screws securely.
Step 6
Locate the ACCESSORY TRAY (#17). Feed the
WIRE HARNESS (E) through the center access
hole. Place the ACCESSORY TRAY on the
CONSOLE SUPPORT ASSEMBLY (#7) as shown.
Using four BUTTON HEAD CAP SCREWS (#18)
and ACORN NUTS (#19), secure the
ACCESSORY TRAY to the CONSOLE SUPPORT
ASSEMBLY through the large mounting holes.
Tighten the screws securely.
Step 7
Attach the 3-PIN (3P) and 10-PIN (10P)
CONNECTORS to the corresponding jacks on the
back of the CONSOLE ASSEMBLY (#4).
(Model 9500HR Only)
Attach the 4-PIN (4P) CONNECTOR to the corresponding jack on the back of the CONSOLE ASSEMBLY
(#4).
Step 8
Place the CONSOLE ASSEMBLY SPACER (#20) onto the CONSOLE SUPPORT ASSEMBLY (#7). Align
the mounting holes in the CONSOLE ASSEMBLY SPACER with those in the CONSOLE SUPPORT
ASSEMBLY.
Step 9
Feed any excess WIRE HARNESS (E) down into the CONSOLE SUPPORT ASSEMBLY (#7). Secure
the CONSOLE ASSEMBLY (#4) to the CONSOLE SUPPORT ASSEMBLY using four PHILLIPS PAN
HEAD SCREWS (#2). Tighten the screws securely.
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS HEAD PAN SCREWS (#2).
CAUTION: BE CAREFUL NOT TO PINCH THE WIRE HARNESS (E) WHEN ASSEMBLING THE
CONSOLE ASSEMBLY (#4) TO THE CONSOLE SUPPORT ASSEMBLY (#7).
6
3P
10P
17
19
2
1
8
Model 9500HR Shown
20
4P
18
7
E
F
4