Life Fitness 8500 Service Manual page 93

Step 1
Before proceeding, familiarize yourself with the parts of
the Cross-Trainer and make sure that you have received
all the items described in the Parts List.
Step 2
Locate the left and right FRONT COVER (#9, #10).
Using two PHILLIPS PAN HEAD SCREWS (#3), mount
the USER LEFT FRONT COVER (#9) to the FRAME
(A). Attach the USER RIGHT FRONT COVER (#10) to
the FRAME in the same manner using two PHILLIPS
PAN HEAD SCREWS (#3). Secure the tops of the
FRONT COVERS together using two PHILLIPS PAN
HEAD SCREWS (#3).
12
D
C
(Model 9500HR Only)
Locate the LEFT USER ARM (#11). Snap the 2-PIN
CONNECTOR (2PA) located at the bottom of the LEFT
USER ARM into the 2-PIN CONNECTOR (2PB)
positioned at the top of the LEFT ROCKER ARM (B).
Feed the connectors and excess cable up into the LEFT
USER ARM. Secure the LEFT USER ARM to the LEFT
ROCKER ARM using three HEX SOCKET HEAD CAP
SCREWS (#1) and INTERNAL LOCK WASHERS
(#23). Repeat the procedure for the RIGHT USER ARM
(#12) and RIGHT ROCKER ARM (C). Tighten all
screws securely.
CAUTION: BE CAREFUL NOT TO PINCH THE WIRE
HARNESSES WHEN ASSEMBLING THE USER
ARMS (#11 & #12) TO THE ROCKER ARMS (B & C)
(Model 9500HR Only).
11
Step 3
(Model 9100 Only)
D
Locate the LEFT USER ARM (#11). Secure the LEFT
USER ARM to the LEFT ROCKER ARM (B) using three
1
HEX SOCKET HEAD CAP SCREWS (#1). Repeat the
procedure for the RIGHT USER ARM (#12) and RIGHT
ROCKER ARM (C). Tighten all screws securely. Slide the
BOOT COVERS (D) located on the user arms down over
the mounting plates.
B
3
3
12
23
C
Model 9500HR Shown
9
A
10
11
1
2PA
2PB
B
5
3