Advertisement
Quick Links
Advertisement
Related Manuals for Life Fitness tr 8500
Summary of Contents for Life Fitness tr 8500
- Page 1 TREADMILL INSTALLATION INSTRUCTIONS...
- Page 2 Congratulations... and welcome to the world of and the Life Fitness 8500 treadmill. The following Parts Identification Listing and the step by step installation procedures have been assembled to make the set-up of your aerobic trainer as quick and easy as possible.
-
Page 3: Safety First
3 feet ( 1 meter ) of the nearest obstruction. Life Fitness recommends a clearance of 6 feet ( 2 meters ) at the rear of the treadmill. The sides of the treadmill should maintain a minimum clearance of 8 inches ( 21 cm ) from the nearest treadmill or other obstruction. - Page 4 OOLS EQUIRED FOR DISPLAY CONSOLE ASS’Y AK45-00036-0001 DISPLAY CONSOLE SCREWS 0017-00101-1148 HANDLEBAR ASSEMBLY AK36-00019-0002 HANDLEBAR WASHERS 0017-00104-0005 LEFT HANDRAIL AK36-00056-0004 HANDRAIL BOLTS 0017-00101-1235 HANDRAIL SCREWS 0017-00101-1210 HANDRAIL SIDE CAP (RIGHT) 0K36-1089-0005 ENDCAP 0K36-01085-0004 TINNERMAN CLIP 0017-00103-0185 SSEMBLY... Phillips screwdriver, Hex key wrench set ARTS ESCRIPTION Qty: 1...
- Page 5 Step 1 Untie and uncoil the WIRE HARNESS attached to the front, right side of the treadmill. Pull gently on the HARNESS to remove any slack. Step 2 Place the RIGHT HANDRAIL next to the treadmill and feed the WIRE HARNESS CONNECTOR into the slot located at the bottom of the RIGHT HANDRAIL (#10) until it exits through the top opening.
-
Page 6: Handlebar Assembly
BRACKETS using two SCREWS (#13) for each HANDRAIL. THE SCREWS (#13) MUST BE FIRMLY TIGHTENED BEFORE TIGHTENING THE HANDRAIL BOLTS (#11) TO INSURE PROPER STABILITY OF THE UPPER TREADMILL. Step 8 Tighten the HANDRAIL BOLTS (#11) securing the base of each of the VERTICAL HANDRAILS to the FRAME of the treadmill. - Page 7 Step 11 The treadmill STRIDING BELT is properly centered at the factory however, the Life Fitness 8500 treadmill must be leveled in the location it is to be used. After placing the treadmill in its intended location for use, check the stability of the unit.
-
Page 8: Operation Checklist
ENGLISH / METRIC DEFAULT SETTING TOGGLE The default setting of the Life Fitness 8500 Treadmill Display Console is set to English units of measurements at the factory. If your Display Console will require units of measurements to be in Metric, it may be necessary to change the setting from English to Metric.