D-Link DI-804HV Manual page 41

Using the Configuration Menu
Advanced > IP Filter
Use IP (Internet Protocol)
filters to allow or deny
computers access to the
Internet based on their IP
address.
Disabled IP Filter-
Select this option if you do not want to use IP filters.
Allow all computers to access the Internet except those listed below-
Those in the list will be denied access to the Internet; all other computers will be allowed
access to the Internet.
Deny all computers access to the Internet except those listed below-
Select this option to deny all computers access to the Internet except those that are
listed below. All other computers will be denied access to the Internet.
Enabled or Disabled-
Click Enabled to apply the filter policy or click Disabled to enter an inactive filter policy
(You can reactivate the policy later.)
IP-
Enter in the IP address range of the computers that you want the policy to apply to. If it
is only a single computer that you want the policy applied to, then enter the IP address of
that computer in the Start Source IP and leave the End Source IP blank.
Port-
Enter in the port range of the TCP/UDP ports that you want the policy to apply to. If it is
only a single port that you want the policy applied to, then enter the port number in the
Start Port field and leave the End Port field blank. If you want to use all the ports, you can
leave the port range empty.
Schedule-
Select Always, or choose From and enter the time period during which the IP filter policy
will be in effect.
41