Control (Cpu) Board - Life Fitness 9500 Series Service Manual

Life Fitness Model 9500 Series HR and Telemetry Equipped Treadmills
How To... REMOVE AND REPLACE THE CONTROL (CPU) BOARD
Tools Required: Standard screwdriver
WARNING: FAILURE TO OBSERVE SAFE PROCEDURES WHEN SERVICING THIS UNIT
Step 1
The current WAXING information on the existing CONTROL BOARD must be recorded for later transfer to the new
CONTROL BOARD. Proceed as follows:
A. Enter into the SERVICE MENU by pressing 919, ENTER (MANUAL, 919, ENTER if connected to
Lifecenter).
B. Record the Treadmill TOTAL MILES (KILOMETERS) and HOURS for your own
records. (This information can not be transferred to the new CPU BOARD.)
c. Press the FIT TEST PROGRAM. The DISPLAY CONSOLE will show the "NUMBER OF TIMES
WAXED" and the "PERCENTAGE OF WAX REMAINING". Record this information for transfer
to the new CONTROL BOARD. Press STOP or CLEAR to exit the SERVICE MENU.
Step 2
Raise the INCLINE of the Treadmill to allow easier access to the CONTROL BOARD.
Step 3
Turn the power OFF at the ON/OFF switch and by unplugging the machine at the electrical outlet.
Step 4
Use a standard screwdriver to "pop" the three PLASTIC RIVETS holding the CONTROL BOARD SHELF in place.
Pull the SHELF down and towards you to lower it on its hinges.
Step 5
To prevent damage to the CONTROL BOARD, ground yourself to the machine with a disposable ANTI-STATIC
STRAP.
26
COULD RESULT IN INJURY FROM ELECTRICAL SHOCK.
(Continued)