Handlebar - Life Fitness 9500 Series Service Manual

Life Fitness Model 9500 Series HR and Telemetry Equipped Treadmills
How To...REMOVE AND REPLACE THE HANDLEBAR
Tools Required: Phillips screwdriver, hex key wrench set, socket and ratchet set
Step 1
.
Turn the power OFF at the ON/OFF switch and by unplugging the machine at the electrical outlet
Step 2
Remove the DISPLAY CONSOLE (See "How To...").
Step 3
Remove the user RIGHT HANDRAIL FOOT COVER (See "How To...").
Step 4
Loosen, but do not remove, the two BOLTS securing the base of the RIGHT HANDRAIL to the Treadmill FRAME.
Step 5
Remove the six SCREWS securing the HANDLEBAR to the two HANDRAILS. Withdraw the HANDLEBAR WIRE
HARNESS with the 4 PIN CONNECTOR from the user LEFT HANDRAIL as you lift out and remove the

HANDLEBAR.

Step 6
Grasp the new HANDLEBAR, and with the WIRE HARNESS to the left, route the WIRE HARNESS through the
opening in the LEFT HANDRAIL, exiting alongside the other WIRE HARNESS. Align the three holes in the
HANDLEBAR FLANGE with those in the LEFT HANDRAIL and re-install the SCREWS. Repeat on the right side.
Step 7
Reverse Steps 1 through 4 to return the Treadmill to operation.
5