Wax Container - Life Fitness 9500 Series Service Manual

Life Fitness Model 9500 Series HR and Telemetry Equipped Treadmills
How To... REMOVE AND REPLACE THE WAX CONTAINER KIT
Tools Required: Socket and ratchet set, two 7/16" wrenches, wire cutting tool, wire ties
Step 1
Turn the power OFF at the ON/OFF switch and then unplug the unit from the electrical outlet.
Step 2
Remove the STRIDING BELT (See "How To...") and the DECK (See "How To..."). Leave the unit on its left side.
Step 3
Use a wire cutting tool to cut the WIRE TIES securing the WAXER HOSE to the FRAME.
Step 4
With your fingers, remove the HOSE CLAMP on the BARBED-FITTING, and seal it off to prevent spillage. Remove
the WAX CONTAINER HOSE from the BARBED-FITTING.
Step 5
Loosen and remove the four MOUNTING BOLTS securing the WAX CONTAINER, COVER and TRAY in place on
the treadmill FRAME.
NOTE: REMOVE THE ENTIRE ASSEMBLY FROM THE TREADMILL AND SET ASIDE.
Step 6
Use two 7/16" wrenches to loosen and remove the four BOLTS and NUTS securing the two BRACKETS through
the WAX CONTAINER into the TRAY.
Step 7
Lift the worn WAX CONTAINER with attached HOSE out of the TRAY and replace it with a new WAX CONTAINER
and HOSE assembly.
NOTE: THE WAX CONTAINER HOSE LENGTH VARIES IN THE MODEL 9500 SERIES. ROUTE THE HOSE
THROUGH THE HOLE IN THE TRAY BEFORE INSTALLING THE COVER.
(Continued)
22