Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood VR-6050 Instruction Manual

Normal playback
Preparing for playback
Listening to a source component
Some prepaiatoty steps are needed before stamng playback
VOLUME CONTROL
POWER
I
ON/STANDBY 0
ON/STANDBY
0 (KRF4'7060DN6060D)
(VR-6050)
A SPEAKERS 0
INPUT MODE
POWER ON/OFF MD/TAPE
(KRF-V7060DN6060D)
Turning on the receiver
0 Turn on the power to the related components.
0 Turn on the power to this receiver by pressing the POWER
ON/STANDBY L!I (for VR-60501 key or POWER ON/OFF and
ON/STANDBY ti (for KRF-V7060D/V6060D) key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO 2
oi DVD/GCH jacks, make sure that the input mode setting IS correct fol
the type of audio sIgnal to be used
-;$
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MDflAPE lacks The lnltial factory setting IS "TAPE" To change the
source to "MD", follow the steps below.
Hold down the MD/TAPE key for more than 2 seconds.
l
The so~irce Indlcatlon changes to "MD"
l
To return to the orIgInal Indlcatlon, repeat the above procedure
Selecting the speaker system
Press the A SPEAKERS B key to select the speaker system to be
used.
AON : Sound ftom the speakers connected to the SPEAKERS A
tennlnals on the rear panel
BON
: Sound from the speakers connected to the SPEAKERS B
telmmals on the rear panel No sound WIII be heard from
ihe subwoofer
A+B ON : Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel
A+B OFF
: No sound from the speakers Use this setting when
IIstenlng witi? headphones for stereo sound in all playback
Imodes. The display segments are different depending 01~
rhe type of input signal
The lndlcator for the speakers
yowl waist to use should be Ilt.
Input Selector AV AUX
VOLUME +I-
INPUT SELECTOR
0 Use the /nput Selector and AVAUX keys to select the
source you want to listen to.
Selecting a source using each key.
VR-6050/KRF-V7060D/V606OD
1 "DVD/GCH"
2 "CDIDVD"
3 "AUX" or "PHONO" (for KRF-V7060D only)
4 "TUNER"
5 "VIDEO 1"
6 "VIDEO 2"
i "VIDEO 3"
8 "MD/TAPE"
9 "AV AUX"
KRF-V6060D (for the U.K. only)
1 "DVD/GCH"
2 "CDIDVD"
3 "PHONO"
4 "TUNER"
5 "VIDEO 1"
6 "VIDEO 2"
7 "VIDEO 3"
8 "MD/TAPE"
9 "AV AUX"
q
Start playback from the selected source.
B Use the VOLUME CONTROL knob or VOLUME +/- keys to
adjust the volume.
0 Selecting "6CH INPUT" by pressing the INPUT MODE key, whereby
"DVDIGCH" IS tile Input source WIII cause SPEAKERS A to be selected
automatically
21 EN