Recording; Recording Audio (Analog Sources); Recordrng Vrdeo - Kenwood VR-6050 Instruction Manual

Recording
sources)
MD/TAPE
Recording e music source
0 Use the Input Selector keys to select the source (other than "MD/
TAPE") you want to record.
0 Set the MD or TAPE recorder to record
0 Start playback, then start recording.
Recording video
0 Use the Input Selector keys to select the video source (other than
"VIDEO 1") you want to record.
0 Set the video deck connected to VIDEO 1 to record.
*Select Ihe REC MODE to record a dIgItal input so~irce
0 Start playback, then start recording.
l
Recordll,g may ,not be ~noimal for some video software 131s IS due
to the copy guard condltlov
- 40
R~~~rd~~~ audio (digital sources)
Sw~tcl? w the REC MODE to record a dqtal input source
Usually use
the
AUTO REC MODE to record audio It?put sources Whet?
the dIgItal mode changes dulng recording I" the AUTO REC MODE, the
audio Input SOLIIC~ may be Interrupted momentat~ly
Recording music in AUTO REC or MANUAL REC mode
DIMMER
Input Selector
0 Use the Input Selector keys to select the source (CD/DVD,
DVD/GCH, VIDEO 2) you want to record.
0 Set the MD or TAPE recorder to record.
0 Press and hold the DIMMER key for more than 2 seconds to
select the AUTO REC or MANUAL REC mode.
2
11
REC MODE off :
AUTO REC mode :
MANUAL REC mode :
The dIgital Input record mode IS
swltched off.
The dIgItal Input signals (DTS, Dolby
DIgItal, or PCM) are ldentlfled auto-
tnatlcally and converted Into stereo
signals that are ready for recording
The Input slgnal type at the moment
thismode ~sselected IS heldthrough-
out this mode
For AUTO REC mode :
For MANUAL REC mode :
, B rnCJ8 0" oPr'CAL
0 Start playback, then start recording
l
If the audio reproduction stops in the lnlddle due to change in the
Input signals, etc press the DIMMER key
23 EN