Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood KRF-A4020 Instruction Manual

Normal playback

ON/STANDBY
10
POWER SPEAKERS A B
MUTE
BASS BOOST
SOURCE DIRECT
VOLUME UP, DOWN
SOUND
BASS BOOST

Preparing for playback

Some preparatory steps are needed before starting playback.
Turning on the receiver
1 Turn on the POWER key to ON.
2 Turn on the power to this receiver by pressing ON/
STANDBY ( ) key.
Selecting MD/TAPE 1 (Main unit only)
Select the source name corresponding to the component
connected to the MD/TAPE1 jacks. The initial factory setting
is "TAPE 1". To change the source name associated with the
MD/TAPE1 jacks to "MD", follow the steps below:
1 Use the INPUT SELECTOR knob to select "TAPE 1".
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to "MD".
• To return to the original indication, repeat the above
procedure.
INPUT SELECTOR
AUTO VOLUME CONTROL
MULTI CONTROL
SOUND
BALANCE
POWER
S. DIRECT
MUTE
BALANCE
MULTI CONTROL
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system
to be used.
A ON : Sound from the speakers connected to the
SPEAKERS A terminals on the rear panel.
B ON : Sound from the speakers connected to the
SPEAKERS B terminals on the rear panel.
A+B ON : Sound from both the speakers connected to
the SPEAKERS A and B terminals on the rear
panel.
A+B OFF : No sound from the speakers. Use this setting
when listening with headphones.
The indicator for the speakers you
want to use should be lit.
SP. A B

Listening to a source component

1
Use the input selector (INPUT SELECTOR) to select
the source you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
1 TUNER (frequency display)
2 "CD"
3 "TAPE 1" or "MD"
4 "PHONO"
5 "AUX"
• When selecting an input source by using the remote
control , press the desired input selector key.
• The INPUT SELECTOR on the front panel of the receiver
always cycles through all inputs.
2
Start playback from the selected source.
3
Use the VOLUME CONTROL (VOLUME UP , DOWN)
to adjust the volume.
• The sound of input source cannot be listened to with
TAPE2/MONITOR is ON.
KRF-A4020 (En/E2T)