Kenwood VR-6050 Instruction Manual page 20

Preparing for surround sound
0 Press the SETUP key again to return to main setup displays.
*The speakers you have selected should appear on the display
Confirm that all the speakers have been correctly selected
q
Select the display mode.
0 Press the A/V keys or Joystick (r/w) to select the DISP
MODE.
0 Press the SETUP key for the following displays:
c
sx DISP SELECTOR
: Displays the current input selector
'5- DISP LISTEN
: Displays the current listen mode
Q Use the MULTI CONTROL knob or Joystick (A/V) to select
the display mode.
0 Press the SETUP key again to accept the setting.
0 Use the A keys or Joystick (~1 to select EXIT.
Input level adjustment (analog sources only)
If the Input level of an analog source slgnal IS too l~~gl?, the CLIP indicator
~111 blink to ir?dlcate the source sIgnal AdjLlst the lnpilt level
tl mu
0 Use the Input Selector keys to select the source of which the
input level you want to adjust.
0 You can store a separate Input level for each InpM solf~ce
0 Press the SOUND and A/V keys or Joystick i-1,) repeatedly
until the "INPUT" indication appears.
0 Use the MULTI CONTROL knob or Joystick In/r) to adjust the
input level.
0 The adjustment mode IS displayed for approxlrmately 8 seconds
*The Input level nlay be adlusted to any one of tlllee settings
OdB, -3dB. and -6dB (The itMa setting IS OdB I
0 Press the SOUND key again to return to the input indication.
0 Press the SETUP key to exit the SET UP mode.
20 EN