Connecting The Fbu Adapter Cable To The Tfm; Concluding Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Expansion cards and backup units
9.3.2.6

Connecting the FBU adapter cable to the TFM

Figure 101: Connecting the FBU to the controller
Ê Connect the FBU cable to the TFM.
Ê Install the RAID controller with TFM as described in section
expansion cards" on page
Ê Route the FBU cable in the same way as the BBU cable.
9.3.2.7

Concluding steps

Perform the following procedures to complete the task:
Check carefully the cable routing and close the cable clamps.
Ê
Ê Close the side cover as described in section
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 59.
Ê If applicable, update the firmware of the RAID controller that has been
connected to the BBU as described in section
firmware" on page
178
150.
"Connecting the server to the mains" on
75.
Upgrade and Maintenance Manual
"Installing
"Installing the side cover" on
"Updating RAID controller
TX100 S3