Replacing An Fbu; Required Tools; Preliminary Steps; Removing The Fbu From The Chassis - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

9.3.6

Replacing an FBU

Upgrade and Repair Units (URU)
Average task duration: 10 minutes
V
CAUTION!
Do not throw battery backup units into the trash can. Batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section
protection" on page
9.3.6.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing an FBU: tool-less
●
9.3.6.2

Preliminary steps

Before replacing an FBU, perform the following steps:
Ê Shut down the server as described in section
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section
page 45.
9.3.6.3

Removing the FBU from the chassis

Ê Remove the FBU from the chassis as described in section
FBU" on page
TX100 S3
38.
"Disconnecting power cord" on page
182.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Shutting down the server" on
"Removing the side cover" on
"Environmental
43.
"Removing an
187