Replacing The Standard Power Supply Unit; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Power supply
6.1

Replacing the standard power supply unit

Field Replaceable Units (FRU)
Average task duration: 10 minutes
6.1.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the power supply unit:
●
– Phillips PH2 / (+) No. 2 screw driver
6.1.2

Preliminary steps

Before replacing the power supply unit (PSU), perform the following steps:
I
You are advised to perform this routine with the server in a horizontal
position.
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page 45.
88
69.
"Disconnecting power cord" on page
Upgrade and Maintenance Manual
"Disabling BitLocker
"Shutting down the server" on
"Removing the side cover" on
43.
TX100 S3