Removing upgrade components
Removing the 512MB cache module
CAUTION:
to bend the controller board.
1.
If you are also going to be removing the BBWC battery:
a.
Back up all data.
b.
Close all applications
2.
power off the server blade and remove it from the server blade enclosure
server blade for
3.
Remove the access panel
4.
Remove the DIMM baffle
5.
Remove any mezzanine card installed in slot 2
6.
Lift the BBWC battery straight up to remove it from the battery mounting bracket.
7.
Pull straight up on the cache module to remove it from the controller.
8.
Push the battery cable down and towards the rear of the server blade to push it out of the
battery bracket's C-hook.
9.
If the controller is installed into slot 1, remove the battery mounting bracket from the mezzanine
card or mezzanine card blank by pulling straight up on the bracket and lifting it out of the
server.
10. Lift the cache module and the attached battery out of the server blade.
CAUTION:
connected so that the data is preserved.
1 1. If you will be replacing the cache module, unplug the battery cable from the cache module
battery connector
Removing the battery mounting bracket
1.
power off the server blade and remove it from the server blade enclosure
server blade for
2.
Remove the access panel
3.
Remove the DIMM baffle
60
Optional components
Only remove/replace the cache module when it is installed in the blade, so as not
servicing").
("Access panel" (page
("DIMM baffle" (page
If you must remove the cache module to transfer data, the battery must remain
("Replacing the 512MB cache
servicing").
("Access panel" (page
("DIMM baffle" (page
113)).
115))
("Mezzanine cards" (page
module").
113)).
115))
("Preparing the
123)).
("Preparing the