Processor And Heatsink Module - HP Integrity BL860c i2 User's & Service Manual

Processor and heatsink module

Processor load order
Observe the following guidelines when installing additional processors:
In a BL860c i2, CPU0 is installed before CPU1.
In a BL870c i2 or BL890c i2, each blade must have CPU0 installed.
When adding additional CPUs in a conjoined configuration:
◦
Load both CPU0 and CPU1 in the Monarch blade first
◦
Load additional CPUs in sequence, from lowest slot-numbered blade to highest.
CAUTION:
replacing the server blade base unit.
CAUTION:
pulled fully out before installation.
CAUTION:
touch the bottom of the processor, especially the contact area.
CAUTION:
multiprocessor configurations must contain processors with the same part number.
The processor and heatsink ship as two separate units and are coupled together during installation
into the server blade.
1. Remove the CPU airflow baffle.
44 Optional components
The pins on the processor socket are very fragile. Any damage to them might require
To avoid damage to the processor, verify that the plastic tabs on the processor are
To avoid damage to the processor, handle the processor only by the edges. Do not
To prevent possible server blade malfunction and damage to the equipment,