Reduced Data Flow In Switched Mode (Scpc - Comtech EF Data Vipersat SLM-5650A User Manual

L o a d S w i t c h i n g
6. If the VMS finds available resources, it processes the switch request and
The modem/router continuously monitors traffic flow volume. Whenever a
preset upper or lower limit is exceeded, the modem/router sends a request to the
VMS to change bandwidth by the amount needed to meet the new requirement.
By this process, the bandwidth is continuously optimized in real time, precisely
accommodating circuit traffic volume.
The ideal condition is for utilization of the channel to reach approximately 90%,
thus optimizing the use of available bandwidth. The ability to actually accom-
plish this is limited by the currently available carrier bandwidth and, ultimately,
the power output and antenna size available at the transmitting Remote site.
If the requested bandwidth is not available, the STDMA Controller will
continue to receive buffer status reports from the Remote indicating that buffer
flow is continuing, and the STDMA Controller will, in turn, continue to request
additional bandwidth from the VMS. When bandwidth does become available,
the VMS will perform the switch the next time that the STDMA Controller
makes the request.
If the video data stream ends before the switch in bandwidth is completed, the
channel is closed, the bandwidth which had been allocated is made available
again to the pool, and no further action is taken.

Reduced Data Flow in Switched Mode (SCPC)

In the event the data flow is reduced—for example, a streaming file transfer
terminates—the SCPC switched demodulator detects the reduced flow and noti-
fies the VMS. The VMS will then send a switch command to reduce the size of
the carrier bandwidth to the newly calculated requirement.
This entire process is automatic, following the policies established for the
network. The network is dynamically modified, changing configuration to auto-
matically respond to changes to the network's load.
The Home Threshold is the bit rate set to trigger a return to the home condition.
This function is used when bandwidth has been allocated to meet load require-
ments, and then the load has been either removed or partially removed. The
Home Threshold is used to determine whether the current bit rate has fallen
below this preset level and, if so, the channel is switched back to its home
condition (STDMA mode, for example).
B-12
channel space (bandwidth) requirements to accommodate the data flow
requested by the STDMA Controller.
sends tuning commands that switch the Remote out of STDMA and into
SCPC mode.
V i p e r s a t S L M - 5 6 5 0 A U s e r G u i d e