Miele KM 2312 Operating And Installation Instructions page 44

Gas hobs
Table of Contents

Advertisement

Flush fit hob
Solid wood and tiled worktops
Worktop
Hob
Gap
Wooden frame 7 mm
(to be provided on site)
As the ceramic glass and the
worktop cut-out have a certain
dimensional tolerance, the size of
gap
can vary.
44
^ Make the worktop cut-out as shown
in "Building-in dimensions".
Remember to maintain the minimum
safety distances (see "Safety
instructions for installation").
^ Fix the wooden frame
below the top edge of the worktop
(see diagram).
^ Feed the connection cable down
through the cut-out.
^ Centre the hob
^ Connect the hob to the mains (see
"Electrical connection").
^ Connect the appliance to the gas
supply (see "Gas connection").
^ Secure the appliance at the back and
front using the fixings supplied. See
"Securing the appliance".
^ Check that the hob works.
^ Seal the remaining gap
silicone sealant that is heat-resistant
to at least 160 °C.
Please follow the manufacturer's
instructions.
For granite and marble tiles only
use a silicone sealant that is
specifically formulated for granite
and marble, and observe the
sealant manufacturer's instructions.
2 mm
in the cut-out.
with a

Advertisement

Table of Contents
loading

Table of Contents