Table of Contents
Advertisement
Controls
Switching on
In the event of a power cut
The control is used to ignite the burner and to regulate the
strength of the flame.
ßThe gas supply is turned off
& Strongest flame
/ Weakest flame
^ The control for the burner required must be pressed in and
turned anti-clockwise to the largest flame symbol to switch
on.
When a control is operated, a spark is produced on all
cooking zones. This is not a fault.
^ When the flame ignites, keep the control pressed in for
8-10 seconds, and then let it go.
^ If the flame goes out, turn the control to "ß". Wait for at least
one minute before trying again, keeping the control
pressed in for a few extra seconds if necessary.
If the burner does not ignite the second time, turn the control
to "ß", and see "Problem solving guide".
If there is an interruption to the electricity supply the gas can
be ignited with a match.
^ Press in the relevant control and turn it anti-clockwise to the
largest flame symbol.
^ Hold the control pressed in and light the gas at the burner
with a match.
Keep the control pressed in for a further 8-10 seconds and
then release it.
Operation
21
Advertisement
Table of Contents
