Miele KM 2014 Operating And Installation Instructions
Hide thumbs
Also See for KM 2014:
- Operating and installation instructions (68 pages) ,
- Operating and installation manual (52 pages) ,
- Operating and installation manual (52 pages)
Table of Contents
Related Manuals for Miele KM 2014
Summary of Contents for Miele KM 2014
- Page 1 Operating and installation instructions Gas hobs To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time. en - GB M.-Nr. 07 181 160...
- Page 2 Per questo se si vuole usare l’apparecchio in un paese diverso rivolgersi al servizio di assistenza tecnica Miele del paese in cui si intende usarlo.
- Page 3 Gas-heated appliances Safety precautions to take if you smell gas ß Turn off the gas emergency control valve immediately. This is usually located near the gas meter. ß Eliminate all sources of ignition in a safe manner. Do not smoke, light cigarette lighters or matches. ß...
-
Page 4: Table Of Contents
Contents Guide to the appliance ..........5 Models . -
Page 5: Guide To The Appliance
Guide to the appliance Models KM 2014 Wok burner Controls: e Front right Small burner cd Medium burners f Rear right g Rear left h Front left... - Page 6 Guide to the appliance KM 2034 / KM 2035 Large burner Controls: f Front right Small burner cd Medium burners g Rear right h Middle Wok burner i Rear left j Front left...
- Page 7 Guide to the appliance KM 2052 Wok burner Controls: f Front right Small burner g Rear right Large burner de Medium burners h Middle i Rear left j Front left...
- Page 8 Guide to the appliance KM 2054 ad Wok burners Controls: f Front right Small burner g Rear right Large burner h Middle Medium burner i Rear left j Front left...
-
Page 9: Burner
Guide to the appliance Burner Wok burner Small, medium and large burners a Burner ring b Burner cap c Burner head d Burner base e Ignition safety device f Ignitor... -
Page 10: Warning And Safety Instructions
It is intended for domestic use only to cook food and keep it warm. Any other usage is not supported by the manufacturer and could be dangerous. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. The gas hob is not intended for outdoor use. - Page 11 Warning and Safety instructions Safety with children This appliance is not a toy! To prevent the risk of injury, do not allow children to play with it or use the controls. Please supervise children whilst you are using the appliance. Children under 8 years of age must be kept away from the hob unless they are constantly supervised.
- Page 12 It is most important that this basic safety requirement is observed and tested regularly, and where there is any doubt, the household wiring system should be inspected by a qualified electrician. Miele cannot be held liable for the consequences of an inadequate earthing system (e.g. electric shock).
- Page 13 If the connection cable is damaged, it must be replaced by a suitably qualified electrician with a special connection cable of type H 05 V V-F (pvc insulated), available from the Miele Spare Parts Department. Do not connect the appliance to the mains electricity supply by a multi-socket adapter or an extension lead.
- Page 14 Warning and Safety instructions In areas which may be subject to infestation by cockroaches or other vermin, pay particular attention to keeping the appliance and its surroundings in a clean condition at all times. Any damage which may be caused by cockroaches or other vermin will not be covered by the guarantee.
- Page 15 If the pan diameter is too large, flames can spread out to the sides and damage or burn the worktop, wall claddings or surrounding units and also parts of the hob. Miele cannot be held liable for this type of damage.
- Page 16 Warning and Safety instructions Remove splashes of fat and other food debris from the surface as soon as possible. These are a fire hazard. Replace the pan supports carefully to avoid scratching the surface of the hob. Using the gas hob will cause a build-up of heat and moisture in the room in which it is installed.
- Page 17 If the appliance has not been used for a long period of time it should be thoroughly cleaned before it is used again. It is also advisable to have the appliance tested for safety. Miele cannot be held liable for damage caused by non-compliance with these Warning and Safety instructions.
-
Page 18: Caring For The Environment
Caring for the environment Disposal of the packing Disposing of your old material appliance The packaging is designed to protect Electrical and electronic appliances the appliance from damage during often contain valuable materials. They transportation. The packaging materials also contain materials which, if handled used are selected from materials which or disposed of incorrectly, could be are environmentally friendly for disposal... -
Page 19: Before Using For The First Time
Before using for the first time Please stick the extra data plate for the appliance supplied with this documentation in the space provided in the "After sales service" section of this booklet. Cleaning for the first time ^ Remove any protective foil and adhesive labels. ^ Clean all removable parts of the burners with a solution of warm water and a little washing-up liquid applied with a soft sponge. -
Page 20: Operation
Operation The control is used to ignite the burner and to regulate the strength of the flame. The burners can only be switched on by pressing in the appropriate control and turning it anti-clockwise, and switched off by turning the control clockwise. The outer flame ring on the wok burner can only be switched on and off by pressing the control in and turning it the appropriate way. -
Page 21: Switching On
Operation Switching on ^ The control for the burner required must be pressed in and turned anti-clockwise to the largest flame symbol to switch Pressing a burner control will automatically create a spark on all burners. This is normal and no cause for concern. ^ When the flame ignites, keep the control pressed in for 8-10 seconds, and then let it go. -
Page 22: Regulating The Flame
Operation Regulating the flame Regulate the flame so that it does not spread out beyond the sides of the pan. As the outer part of the flame is much hotter than the centre, the tips of the flames should stay beneath the pan base. -
Page 23: Suitable Pans
Suitable pans Burner Min. pan base diameter in cm Small burner Medium burner Large burner Wok burner Max. diameter at top of pan in cm Small burner Medium burner Large burner Wok burner – Refer to the chart above and ensure that the pan diameter falls within the minimum and maximum diameters given for the burner you are using. - Page 24 Suitable pans – Remember when purchasing new pans that manufacturers usually refer to the diameter at the top of the pan in their documentation. – Use a pan lid whenever possible to minimise heat loss. When placing pans on the pan support(s) make sure you position them so that they cannot tip up.
-
Page 25: Safety Cut-Out
Safety cut-out This appliance is fitted with a thermoelectric ignition safety device which cuts off the supply of gas to a burner if the flame goes out, for example if food has boiled over, or if there was a sudden draught. ^ To use the burner again, turn the control clockwise to the "ß"... -
Page 26: Cleaning And Care
Cleaning and care For Miele branded and cleaning and conditioning products see “Optional accessories”. Do not use a steam cleaning appliance to clean this appliance. The steam could reach electrical components and cause a short circuit. – The appliance should be cleaned after each use. Allow the appliance to cool down to a safe temperature before cleaning. - Page 27 Remove any soiling which applied with a soft sponge. comes into contact with the If necessary, you could use Miele ceramic and printed flame symbols straight stainless steel hob cleaner (see "Optional away. Soiling, particularly accessories") and the scouring pad on the...
- Page 28 Cleaning and care To assemble the small, medium and large burners ^ Place the burner head c onto the burner base d so that the the ignition safety device e, the ignitor f and the retaining pins g fit into their respective holes in the burner head.
- Page 29 Cleaning and care To assemble the wok burner ^ Place the burner head c onto the burner base d so that the holes fit over the jets in the burner base and the locating bar in the notch. If the burner head is correctly in position, it does not move about.
-
Page 30: Problem Solving Guide
– the flame slits are dry and unblocked. – the mains fuse has tripped. If it has, contact a qualified electrician or the Miele Service Department. The gas can be lit with a match. (See “Use during a power cut”). - Page 31 ... the ignitor on the burner does not spark. – check whether the mains fuse has tripped. If it has, contact a qualified electrician or the Miele Service Department. – Check whether food deposits have lodged themselves between the ignitor and the burner cap.
-
Page 32: Optional Accessories
Miele offer a comprehensive range of useful accessories as well as cleaning and conditioning products for your Miele appliances. These can be ordered online at: or from Miele (see back of manual for contact details). Cleaning products Ceramic and stainless steel hob cleaner 250 ml... -
Page 33: Safety Instructions For Installation
Safety instructions for installation The electrical cable (and a flexible Fit the wall units and extractor hood gas connection pipe in countries where before fitting the hob to avoid applicable) must be installed in such a damaging the surface. way so that they do not come into contact with any moving kitchen parts The room in which the gas hob is (e.g. - Page 34 Safety instructions for installation Safety distance above the hob When two or more appliances are installed together below a cooker hood, e.g. a gas hob and an induction hob combiset, which have different safety distances given in the installation instructions, you should select the greater distance of the two.
- Page 35 Safety instructions for installation Ideally the hob should be installed with plenty of space on either side. There may be a wall at the rear and a tall unit or wall at one side. On the other side, however, no unit or divider should stand higher than the hob (see illustrations).
-
Page 36: Appliance And Building-In Dimensions
Appliance and building-in dimensions KM 2014 5 2 0 6 5 0 ß R 4 8 0 - 4 9 2 1 7 1 9 6 a Front b Casing depth c Gas connection R 1/2" ISO 7-1 (DIN EN 10226) - Page 37 Appliance and building-in dimensions KM 2034 / KM 2035 5 2 0 7 5 0 ß R 0 5 0 4 8 0 - 4 9 2 1 7 1 9 6 a Front b Casing depth c Gas connection R 1/2" ISO 7-1 (DIN EN 10226) d Mains connection box with mains connection cable, L = 2000 mm...
- Page 38 Appliance and building-in dimensions KM 2052 / KM 2054 5 2 0 9 0 0 ß R 0 5 0 4 8 0 - 4 9 2 1 7 1 9 6 a Front b Casing depth c Gas connection R 1/2" ISO 7-1 (DIN EN 10226) d Mains connection box with mains connection cable, L = 2000 mm...
-
Page 39: Installation
Installation Preparing the worktop Installing the hob ^ Make the worktop cut-out following ^ Feed the connection cable down the dimensions applicable. through the cut-out. Remember to maintain a minimum ^ Place the hob in the cut-out without safety distance from the back wall, securing it. -
Page 40: Tiled Worktop
Installation General installation tip Tiled worktop Grout lines a and the hatched area Do not use any sealant unless underneath the hob frame must be expressly instructed to do so. The smooth and even. If they are not the sealing strip under the edge of the top hob will not sit flush with the worktop part of the appliance provides a and the sealing strip underneath the... -
Page 41: Electrical Connection
Electrical connection Connection should be made via a All electrical work should be carried suitable isolator or a double pole fused out by a suitably qualified and spur connection unit which complies competent person, in strict with national and local safety accordance with current local and regulations and the on/off switch should be easily accessible after the appliance... - Page 42 If the connection cable is damaged, it must be replaced by a suitably qualified electrician with a special connection cable of type H 05 V V-F (pvc insulated), available from the Miele Service Department. The manufacturer cannot be held liable for damage which is the direct or indirect result of incorrect installation or connection.
-
Page 43: Gas Connection
Please contact your dealer or the Miele Spare Parts Department for the Check with your local gas supplier appropriate conversion jets if about the type of gas and its necessary. - Page 44 Gas connection Connection The gas connection must be installed so that connection can be made either from inside or outside the kitchen unit, and the isolating valve must be easily accessible and visible (by opening one of the kitchen doors, if necessary). After installing the appliance the gas burners have to be set for local conditions.
-
Page 45: Burner Ratings
Burner ratings Nominal ratings for all gas types with the burner full on Burner Gas type KM 2014 KM 2034 / KM 2035 / KM 2052 Small Natural gas burner Liquid gas Medium Natural gas 1.75 1.75 burner Liquid gas 1.75... - Page 46 Burner ratings Nominal rating at low setting Burner Gas type KM 2014 KM 2034 / KM 2035 / KM 2052 / KM 2054 Small Natural gas 0.25 0.25 burner Liquid gas 0.25 0.25 Medium Natural gas 0.35 0.35 burner Liquid gas 0.35...
-
Page 47: Conversion To Another Type Of Gas
Conversion to another type of gas Jet table Connection to the gas supply, or conversion from one type of gas to another, should only be undertaken by an approved and registered gas installer in strict accordance with local and national safety and building regulations (e.g. -
Page 48: Changing The Jets
Conversion to another type of gas Changing the jets Wok burner Disconnect the gas hob from the electricity supply by switching off at the socket or by disconnecting the mains fuse. To change the main jets Small, medium and large burners ^ Remove burner cap b, burner ring a and burner head c. -
Page 49: To Change The Small Jets
Conversion to another type of gas To change the small jets Small, medium and large burners The top of the appliance has to be removed before the small jets can be changed. ^ Loosen the fixing screws on the burners. ^ Pull the control knobs off. - Page 50 Conversion to another type of gas Wok burner ^ Remove ignitor a. ^ Using a small screwdriver, unscrew small jets b and c in the gas fitting. ^ Pull out the jets with a pair of pliers. ^ Fit the correct jets securely (see jet table).
-
Page 51: After Changing The Jets
Conversion to another type of gas After changing the jets ^ Reassemble the burner parts in the reverse order, ^ Check all gas fittings for leaks by operating the burner without the top section of the hob in place (use a match to ignite the flame). -
Page 52: After Sales Service, Data Plate, Guarantee
Guarantee For information on the appliance guarantee specific to your country please contact Miele. See back of manual for contact details. In the UK, your appliance is guaranteed for 2 years from the date of purchase. However, you must activate... - Page 56 KM 2014 / KM 2034 / KM 2035 / KM 2052 / KM 2054 en - GB M.-Nr. 07 181 160 / 06...