Table of Contents
Advertisement
Cleaning and care
Stainless steel
surfaces
Pan supports
Controls
Burner cap
Burner head
Ignitor
Ignition safety
device
28
Cleaning
Clean stainless steel surfaces using an E-Cloth
(see "Optional accessories") or with a solution
of warm water and a little washing-up liquid
applied with a soft sponge.
If necessary, you could use Miele ceramic and
stainless steel hob cleaner (see "Optional
accessories") and the scouring pad on the
reverse of a washing-up sponge. Apply with
an even pressure following the direction of the
"grain".
Miele conditioning agent for stainless steel can
be used after cleaning to help prevent
re-soiling (see "Optional accessories"). Follow
the instructions on the packaging.
Remove the pan supports.
Wash them in the dishwasher or with a
sponge and warm water with a little
washing-up liquid. If necessary, you could use
the scouring pad on the reverse of a
washing-up sponge.
Clean the controls with a solution of warm
water and a little washing-up liquid applied
with a soft sponge.
Clean the burner caps using an E-Cloth (see
"Optional accessories") or with a solution of
warm water and a little washing-up liquid
applied with a soft sponge.
If necessary, you could use the scouring pad
on the reverse of a washing-up sponge.
Clean the burner heads using an E-Cloth (see
"Optional accessories") or with a solution of
warm water and a little washing-up liquid
applied with a soft sponge.
If necessary, you could use the scouring pad
on the reverse of a washing-up sponge.
The ignitors and ignition safety devices should
be very carefully wiped clean using a well
wrung out cloth.
Notes
Printed surfaces
(Flame symbols)
Remove any soiling which
comes into contact with the
printed flame symbols
straight away. Soiling,
particularly salty food or
liquid and olive oil, can cause
damage if left on the printed
surfaces for a long time.
Do not use stainless steel
cleaning agents on the
printed flame symbols. This
would rub off the print.
Not dishwasher proof.
Not dishwasher proof.
Not dishwasher proof.
Make sure that the flame slits
are completely dry after
cleaning.
Do not let the ignitors get
wet. If they get wet they will
not spark.
Advertisement
Table of Contents
