Installing The Jig Drivers On The Pc; Installing And Starting The Adjustment Software; Initializing The Adjustment Software - FujiFilm FinePixS5000 Service Manual

FinePix S5000 Service Manual

4-6. Installing the Jig Drivers on the PC

* As this device uses a USB interface for communica-
tions with the PC, the [USB Jig Driver] must first be
installed on the PC before the PC adjustment software
can be run.
* As the USB Jig Driver is the same for all models after
March 2003, this jig driver is already installed on the
PC. This driver software need not be installed on PCs
in which the USB device is already been adjusted.
<Step 1>
Insert the DSC jig driver setup floppy disk (ZJ00476-
101) in the floppy disk drive on the PC.
<Step 2>
Double-click on [setup.exe](Fig.D) on the floppy disk,
and follow the instructions on the screen to install the
jig driver.
The jig driver will be saved in [C:\Program Files\Fig].
4-7. Installing and Starting the Adjust-
ment Software
<Step 1>
Insert the FinePix_ S5000_W adjustment software
media (ZJ00674-100) in the drive on the PC.
<Step 2>
Copy each of the folders in the [FinePix_S5000_W]
folder to the C: drive on the PC (Fig.E).
<Step 3>
When all the folders have been copied to the C:
drive, double-click on
[C:\FinePix_S5000_W\FFW.exe] (Fig.E) to start
the adjustment software.
* The adjustment software will not operate correctly
unless the FinePixF_S5000_W folder is located in the
C:\ directory. Do not change the directory configura-
tion or folder name.

4-8. Initializing the Adjustment Software

* As the initial setup is located in the [FFW.ini] file,
follow the procedure below. Note that the software will
not run if the file name is changed.
* As the initialization described in Steps 3, 4, 5, and 6 is
included in the [FFW.ini] file, the user is only required
to check details.
* Do not overwrite the user program (FX_S5000_W.ff)
under any circumstances. The software will not run if
the user program is overwritten.
4. Adjustments
<Fig.D>
<Fig.E>
<Fig.F>
39