4-2-6.Install The Dsc Jig Driver And The Pc Adjustment Software - FujiFilm FinePix 2600Zoom Service Manual

FinePix2600Zoom (U/E/EG) SERVICE GUIDE
(Caution)[Important]
(a) PC adjustment software can not start when there is folder of
FinePix2600ZU_E in folder named ZJ00505-100.(Fig.D-1)
Please preserve the folder of FinePix2600Z_UE right under C drive.(Fig.D-2)
(b) Please do not change the foldername named FinePix2600Z_UE.
PC adjustment software can not start when foldername is changed.
4-2-6.Install the DSC jig driver and the PC adjust-
ment software
* Since this camera uses the USB for communications with the
personal computer, in order to start the PC adjustment soft-
ware, [the DSC jig driver] needs to be installed in the personal
computer beforehand.
* The DSC jig driver is the same as that for the FinePix 6800Z,
so if this jig driver software is already installed in the personal
computer, it is not necessary to install it.
The procedure is given below.
(1)Installation of DSC jig driver
<step 1>
DSC jig driver(ZJ00476-100.ZIP) is downloaded from Web
server (http://fujifilm-di.intranets.com/).
<step 2>
Defrost the downloaded compression software
<step 3>
Double-click setup.exe in the folder of defrosted ZJ00476-
100 and install Fuji FILM DSC Jig Driver as follows.
<step 4>
Install the software in [C:\ProgramFiles\Fjig]
according to the instructions on the PC's screen.
(2)Startup of PC adjustment software
When the folder has been copied to the C drive, double-click on the
file C:\FinePix2600Z_UE\ffw217.exe (Fig.D-3(1)) to start the adjust-
ment software.
4. Adjustment and Inspection
<Fig.D-3> ffw217.exe screen display (Windows Explorer)
(1)
17