FujiFilm FinePixS5000 Service Manual page 70

5. Inspection
Item
Sequence
5 Movie recording
check
6 Movie playback
check
7 Card cover detect
check
8 Delete mode
check
10 Battery low check
11 Current
consumption
check
12 Factory setting
70
Preparations for adjustment
Mode
(measurement points, subject, other)
Movie
(1) Select Movie mode.
photography
(2) Half-press shutter button
LCD_ON
-> full-press release.
(3) Five seconds later -> full-
press release.
Playback
(1) Select Playback mode.
(2) Press '+' key to playback
movie.
M mode
(1) Open card cover to check
LCD_ON
recording.
(2) Remove card.
Delete
(1) Select <Delete all frames>
from the menu, and press
the <OK> button.
(2) Press the <OK> button
again.
Movie
(1) Connect power cable jig
(2) Set voltage.
(3) Set mode dial to Replay
mode, and switch main
power ON.
(4) Set to pre-end voltage.
(5) Set to end voltage.
Auto
(1) Connect power cable jig.
photography
(2) Set voltage.
LCD_ON
(3) Set mode dial to Camera
mode, and switch main
power ON.
(4) Press the <DISP> button
to switch the LCD monitor
ON.
(5) After the through screen is
displayed, check current
consumption.
(1) Mode dial: Auto mode
Playback
(2) Return all settings to initial
values.
Flash:
Monitor brightness: Center
Power lever:
USB setting:
Beep:
Language:
Pixels:
Photography mode: AUTO
Date:
(3) Inspection battery/
inspection xD-Picture card
not inserted in camera.
(4) Battery cover closed.
(5) LCD surface free of
contamination.
(6) Clean exterior of camera.
FinePix S5000 Service Manual
Method of adjustment
(VRs, waveforms, required values)
(1) Standby display on LCD.
(2) Movie recording begins.
Recording displayed on
LCD.
(3) Movie recording
completed. Recording on
card.
(2) Movie played back on
LCD monitor.
(1) Switch power OFF.
(1) [ERASE ALL OK? IT
MAY TAKE A WHILL]
displayed.
(2) Movie/photography
screen extinguished.
Refer to Battery Adjustment
for connection details.
(2) Set voltage to 5.0±0.5V.
(3) Starts normally.
(4) Set voltage to
4.25±0.02V. Battery
warning displayed.
(5) Set voltage to
4.00±0.02V. Lens
retracts and main power
switched OFF.
(2) Set voltage to 5.00±0.05V.
(5) Maximum current
consumption 450mA.
* Setting and clearing date
(1) Connect the USB cable
from the PC to the camera
(ensure that the PC is
Retracted
switched ON).
(2) Open the card cover and
OFF
switch power ON
Card reader
(POWER_ON) while
LOW
pressing the shutter
Engrish
button.
1M normal
(3) Switch power OFF
(POWER_OFF).
Not set
(4) Check that the date has
been cleared.
Measurement points
Measuring
equipment
(VRs, positions)
and jigs
LCD monitor
Power supply
cable jig
Regurated
power supply
Ammeter