Cruise Control; Cutting Height Adjustment - Stiga PARK PRO DIESEL Owner's Manual

ating position 2.
When the key is turned from position 1 to position
2, a warning buzzer for oil pressure can be heard.
This buzzer will stop when the engine has been
running for a few seconds. If the buzzer does not
stop, turn off the engine and check the engine oil
level.
NOTE! If the engine should stop for any reason,
the key cannot be turned directly to position 3
due to a mechanical ignition lock. To start the
engine - turn the key back to position 1 and then
to positions 2 and 3.
9. POWER TAKE-OFF
Switch for engaging/disengaging the electromag-
netic power take-off for driving front-mounted ac-
cessories. There are two positions:
1. Press the front part of the switch – the
power take-off is engaged. The symbol
will light up.
2. Press the rear part of the switch – the
power take-off is disengaged.
NOTE! The hydraulic implement lifter must be
in floating position in order for the power take-
off to be connected.
10. DIFFERENTIAL INHIBITOR
Lever for engaging the differential inhibitor. This
improves the towing capacity by locking the rear
wheels so that both wheels drive simultaneously.
There are two positions:
1. Forward position – the differential in-
hibitor is not engaged. For normal opera-
tion.
2. Lever in backward position - differen-
tial inhibitor engaged. Works for both for-
ward and reverse drive.
The differential inhibitor is of greatest use when
the rear wheels are unevenly loaded. For example,
when driving across a slope, where the upper rear
wheel is not as loaded, as well as when turning
sharp corners where the inner rear wheel bears a
lesser load.
When driving in the winter on slippery surfaces,
the drive capacity is also improved.
When the differential inhibitor is engaged, the
steering is heavy. Avoid turning the steering
wheel!
ENGLISH
11. HOUR COUNTER
Indicates the number of working hours. Only
works when the engine is running.

12. CRUISE CONTROL

A switch for activating the cruise control. The
cruise control allows the drive pedal (5) to be
locked in the desired position. You do not need to
use your right foot.
1. Press down the drive pedal until the de-
sired speed is obtained. Then press the
front part of the switch to activate the
cruise control. The symbol will light up.
2. Disengage the cruise control by press-
ing the rear part of the switch.

13. CUTTING HEIGHT ADJUSTMENT

The machine is equipped with a control for using
the cutting deck with electrical cutting height ad-
justment.
The switch is used to adjust the cutting
height in continuously variable positions.
The contact used for connecting the cutting deck is
mounted on the right side, in front of the front
wheel (fig. 2).
14. REAR RAKE
The machine is fitted with a control for electrical
adjustment of a rear rake (available as an accesso-
ry).
The switch is used to raise and lower the
rear rake.
Cables for connecting the rear rake are found at the
rear of the machine, to the right of the upper side
of the bumper.
15. SAND SPREADER
The machine is fitted with a control for using the
electrical sand spreader (available as an accessory).
The switch is used to start and stop the
12V
spreader.
Cables for connecting the sand spreader are found
at the rear of the machine, to the right of the upper
side of the bumper.
GB