Using Priority; Turning The Key Tone On And Off; Advanced Operation; Cloning The Programmed Data - Radio Shack 20-405 User Manual

Using Priority

The priority feature sets the scanner to check one channel every two seconds
while scanning. You can program one frequency into the priority channel.
1. Press PGM, then press PRI/ALERT. PCH and 000.000
stored frequency) appear.
2. Enter the frequency you want stored in the priority channel, then press ENT.
. To turn on the priority feature, press PRI/ALERT during scanning or
searching. PRI appears. The scanner checks the priority channel every two
seconds and stays on the channel if there is activity.
• To turn off the priority feature, press PRI/ALERT. PRI disappears.
• To program a weather channel as the priority channel, see "Receiving All
Weather Alerts" on page 21.

Turning the Key Tone On and Off

The scanner is preset to sound a tone each time you press one of its keys.
To turn the key tone on and off:
1. If the scanner is on, turn it off then back on again.
2. WELCOME SCAnnInG rECEIVEr appears.
. While the welcome message is on the screen, press 1 to turn on the key
tone or press 2 to turn it off.

Advanced Operation

Cloning the Programmed Data

You can transfer the programmed data to and from a PRO-405 scanner using
an optional connecting cable with Ç-inch (3.5mm) stereo phone plugs on both
ends (available from your local RadioShack store or www.RadioShack.com).
1. Turn on both scanners.
2. Connect the connecting cable to each scanner's PC/IF jack. CLOnE and UP
to SEnd appears.
. Press e on the host scanner.
4. SEndInG appears at the host scanner.
To exit clone mode after the data transfer is complete, remove the cable.
No ConnEct appears if you try to connect to another model scanner. The PRO-
405 does not clone with other scanner models.
0
25
(or the previously